|
|
| We Are Your One-Stop-Shop Standards Solution |
 |
|
|
|
|
|
ANSI A156.7
- Complete Document
|
|
Revision / Edition: 09
Chg:
Date: 00/00/09
|
|
TEMPLATE HINGE DIMENSIONS ***SAME AS BHMA 111*** *** SEE ALSO BHMA HANG THE DOOR SET & ANSI A156 SERIES ***
|
|
Comments:
|
|
|
Superseding Document:
|
|
|
Page Count:
|
22
|
|
In Stock:
|
Yes
|
|
Hardcopy Price:
|
$ 36.00 |
 |
Secure PDF Price  : |
$ 36.00 |
|
| Document Abstract |
This Standard covers the requirements for the length, width,
thickness, offset, and screw hole spacing for builders template
hinges. Included in the standard are hinge identification symbols
and screw sizes. Methods for identifying template hinges that
conform to the Standard are provided.
Classification This Standard covers the
following types of builders template hinges:
Full mortise hinge A hinge designed for
mortising into the butt edge of the door and into the rabbet edge
of the door frame. Used generally with steel frames and steel
doors.
Full surface hinge A hinge designed to be
applied to the surface of the door and the surface of the door
frame. Used generally with channel iron frames and metal covered
doors.
Half mortise hinge A hinge designed to be
mortised into the butt edge of the door and applied to the surface
of the door frame. Used generally with channel iron frames and
steel doors.
Half surface hinge A hinge designed to be
applied to the surface of the door and mortised into the rabbet
edge of the door frame. Used generally with steel frames and metal
covered doors.
Slip-in hinge A hinge designed for one or both
leaves to slide into a cavity prepared in a door or door frame thus
concealing one or both hinge leaves. Used generally with aluminum
frames and doors.
Swing clear hinge A hinge designed to swing a
door completely clear of the opening when the door is opened 90 to
95 degrees. It can be full mortise, full surface, half mortise or
half surface. Used generally with frames and doors as described in
2.2.1 through 2.2.4 as applicable.
PURPOSE
The purpose of this Standard is to establish nationally
recognized dimensions for builders template hinges which are used
on metal doors and frames. This Standard is intended to assure the
interchangeability of template hinges and to provide a uniform
method for template identification.
|
| Customers who purchased ANSI A156.7 have also purchased |
| | ANSI A156.18 : MATERIALS AND FINISHES ***SAME AS BHMA 1301*** |
| | ANSI A156.5 : AUXILIARY LOCKS AND ASSOCIATED PRODUCTS **SAME AS BHMA 501* *NO HOLE REQUIRED - BEST COPY AVAILABLE** |
| | ANSI C12.18 : PROTOCOL SPECIFICATION FOR ANSI TYPE 2 OPTICAL PORT |
| | ANSI Z97.1 : FOR SAFETY GLAZING MATERIALS USED IN BUILDINGS - SAFETY PERFORMANCE SPECIFICATIONS AND METHODS OF TEST |
| | More Documents |
|
|
