IHS - Document Details


	Home \| My Account \| Shopping Cart \| Help & Support \| About \| Contact Us

	Document Number	Title / Keyword	Search By Publisher
STANDARDS SEARCH:

		Shop By Industry

		- Boilers & Pressure Vessels - Electronics/Electrical/Telecom - Energy & Petrochem - Health & Safety - Quality Management - Water & Wastewater Quality - ECA eStore - AIA/NAS eStore - NEMA eStore

		Featured Products

		- Alerts & Content Tools - ASTM Book of Standards - ASME Boiler & Pressure Vessels - National Board NBIC - Drawing and Drafting - Power & Process Piping - Telecommunications Standards - Smart Grid Meters - ISO 9000 - The 9000 Store

		Services

		- Abbreviations - Customer Service - Deposit Accounts - Free Catalogs - Free Newsletters - New/Revised Docs - Research Center - Standing Orders - Search Help

We Are Your One-Stop-Shop Standards Solution

Document Details

Return to search results

Prices displayed in United States Dollars (USD)

ISO/IEC 7811-2 - Complete Document

Revision / Edition: 01 Chg: Date: 02/01/01

IDENTIFICATION CARDS - RECORDING TECHNIQUE - PART 2: MAGNETIC STRIPE ** SEE ALSO DIN EN ISO/IEC 7811-2 **

Comments:	THIRD EDITION * ENGLISH ONLY
Superseding Document:
Page Count:	27
In Stock:	Yes
Hardcopy Price:	$ 130.00
Download Price:	$ 104.00

Document Abstract

This part of ISO/IEC 7811 is one of a series of standards describing the characteristics for identification cards as defined in the definitions clause and the use of such cards for international interchange.

This part of ISO/IEC 7811 specifies requirements for a low coercivity magnetic stripe (including any protective overlay) on an identification card, the encoding technique and coded character sets. It takes into consideration both human and machine aspects and states minimum requirements.

Coercivity influences many of the quantities specified in this part of ISO/IEC 7811 but is not itself specified. Exposure of the card to a magnetic field is likely to destroy the recorded data.

It is the purpose of this series of standards to provide criteria to which cards shall perform. No consideration is given within these standards to the amount of use, if any, experienced by the card prior to test. Failure to conform to specified criteria should be negotiated between the involved parties.

ISO/IEC 10373-2 specifies the test procedures used to check cards against the parameters specified in this part of ISO/IEC 7811.

NOTE Numeric values in the SI and/or Imperial measurement system in this part of ISO/IEC 7811 may have been rounded off and therefore are consistent with, but not exactly equal to, each other. Either system may be used, but the two should not be intermixed or reconverted. The original design was made using the Imperial measurement system.

View Previous Revisions

Customers who purchased ISO/IEC 7811-2 have also purchased
	ISO/IEC 7810 : IDENTIFICATION CARDS - PHYSICAL CHARACTERISTICS
	ISO/IEC 7811-1 : IDENTIFICATION CARDS - RECORDING TECHNIQUE - PART 1: EMBOSSING
	ISO/IEC 7811-6 : IDENTIFICATION CARDS - RECORDING TECHNIQUE - PART 6: MAGNETIC STRIPE - HIGH COERCIVITY
	ISO/IEC 7811-3 : IDENTIFICATION CARDS - RECORDING TECHNIQUE - PART 3: LOCATION OF EMBOSSED CHARACTERS ON ID-1 CARDS SAME AS DIN EN 27811 P3 NOT AVAILABLE IN THE US SEE ANSI/ISO/IEC 7811-1 FOR US SALES
	More Documents