Language:
    • Available Formats
    • Options
    • Availability
    • Priced From ( in USD )
    • Printed Edition
    • Ships in 1-2 business days
    • $48.00
    • Add to Cart
    • Printed Edition + PDF
    • Immediate download
    • $65.00
    • Add to Cart

Customers Who Bought This Also Bought

 

About This Item

 

Full Description

1.1 This test method covers certain material specifications for which a history of data has been obtained using the standard microtensile specimen. In general, this test method is superseded for general use by either Test Method D882 or Test Method D638. The very small Type V specimen in Test Method D638 is the recommended specimen when limited amounts of material are available.

1.2 This test method covers the determination of the comparative tensile strength and elongation properties of plastics in the form of standard microtensile test specimens when tested under defined conditions of pretreatment, temperature, humidity, and testing machine speed. This method is applicable when using specimens of any thickness up to 3.2 mm (1/8 in.), including thin films.

1.3 This test method cannot be used for the determination of modulus of elasticity. For the determination of modulus, see Test Method D638 or Test Methods D882.

1.4 Data obtained by this test method are relevant and appropriate for use in engineering design.

Note 1: Tensile properties provide useful data for plastics engineering design purposes. However, because of the high degree of sensitivity exhibited by many plastics to rate of straining and environmental conditions, data obtained by this test method cannot be considered valid for applications involving load-time scales or environments widely different from those of this test method. In cases of such dissimilarity, no reliable estimation of the limit of usefulness can be made for most plastics. This sensitivity to rate of straining and environment necessitates testing over a broad load-time scale (including impact and creep) and range of environmental conditions if tensile properties are to suffice for engineering design purposes.

1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 2: There is no known ISO equivalent to this standard.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 

Document History

  1. ASTM D1708-18

    👀currently
    viewing


    Standard Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens

    • Most Recent
  2. ASTM D1708-13


    Standard Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens

    • Historical Version
  3. ASTM D1708-10


    Standard Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens

    • Historical Version
  4. ASTM D1708-06a


    Standard Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens

    • Historical Version
  5. ASTM D1708-06


    Standard Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens

    • Historical Version
  6. ASTM D1708-02a


    Standard Test Method for Tensile Properties of Plastics By Use of Microtensile Specimens

    • Historical Version
  7. ASTM D1708-96


    Standard Test Method for Tensile Properties of Plastics By Use of Microtensile Specimens

    • Historical Version