1.1''This test method covers the measurement of residual moisture in refuse-derived fuel (RDF) analysis samples. It is used to calculate on a dry basis other determinations performed on analysis RDF samples. It is used with air-dry moisture results to calculate total moisture (Note 1). The total moisture is used to calculate as-received values or other analyses performed on a sample.

1.2''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For more specific precautionary information, see Section 7.

1.4''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.