Hello. Sign In
Standards Store

ASTM B108/B108M

2018 Edition, May 15, 2018

Complete Document

Standard Specification for Aluminum-Alloy Permanent Mold Castings



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$67.00
Print
In Stock
$67.00
PDF + Print
In Stock
$113.90 You save 15%
Add to Cart

People Also Bought These:

ASTM E18
ASTM A370
ASTM A240/A240M
ASTM E10

Product Details:

  • Revision: 2018 Edition, May 15, 2018
  • Published Date: May 15, 2018
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 23
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This specification2 covers aluminum-alloy permanent mold castings designated as shown in Table 1.

This specification is for aluminum-alloy permanent mold castings used in general purpose applications. It may not address the mechanical properties, integrity testing, and verification required for highly loaded or safety critical applications.

Alloy and temper designations are in accordance with ANSI H35.1/H35.1(M).

Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.

For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2.

Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

2 For ASME Boiler and Pressure Code application see related SB-108.

*A Summary of Changes section appears at the end of this standard