Hello. Sign In
ASA Standards Store in partnership with IHS Markit
 
 
Look Inside

ANSI/ASA S12.53 PART 2

1999 Edition, October 18, 1999

Complete Document

American National Standard Acoustics – Determination of sound power levels of noise sources using sound pressure – Engineering methods for small, movable sources in reverberant fields - Part 2: Methods for special reverberation test rooms - Nationally Adopted International Standards

Includes all amendments and changes through Reaffirmation Notice , January 26, 2015


View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
SAME AS ISO 3743-2
Format
Details
Price (USD)
PDF
Single User
$69.00
Print
In Stock
$69.00
PDF + Print
In Stock
$96.60 You save 30%
Add to Cart

People Also Bought These:

ANSI/ASA S12.51/ISO 3741
ANSI/ASA S12.55/ISO 3745
ANSI/ASA S12.53 PART 1
ANSI/ASA S12.50/ISO 3740

Product Details:

  • Revision: 1999 Edition, October 18, 1999
  • Published Date: January 26, 2015
  • Status: Active, Most Current
  • Document Language: English
  • Published By: Acoustical Society of America (ASA)
  • Page Count: 38
  • ANSI Approved: Yes
  • DoD Adopted: No

Description / Abstract:

General.

This part of ISO 3743 specifies a relatively simple engineering method for determining the sound power levels of small, movable noise sources. The measurements are carried out when the source is installed in a specially designed room having a specified reverberation time over the frequency range of interest. The A-weighted sound power level of the source under test is determined from a single A-weighted sound pressure level measurement at each microphone position. rather than from a summation of octave-band levels. This direct method eliminates the need for a reference sound source. but requires the use of a special reverberation test room. The direct method is based on the premise that the sound pressure level. averaged in space and time in the test room. can be used to determine the sound power level emitted by the source. The properties of the special reverberation test room are chosen so that the room's influence on the sound power output of the equipment under test is small. The number of microphone positions and source locations required in the test room are specified. Guidelines for the design of special reverberation rooms are given in annex B.

In addition to the direct method. a comparison method is also described (see 8.3). However, since the requirements on the test room for the comparison method of ISO 3743-1 are considerably less restrictive. it is recommended that the comparison method of ISO 3743-1 be used if a special reverberation test room is not available.

NOTE 1 Precision methods for the determination of the sound power levels of small noise sources are specified in ISO 3741 and ISO 3745.