Hello. Sign In
Standards Store




ASME PTC 28

1965 Edition, 1965

Complete Document

Determining the Properties of Fine Particulate Matter

Includes all amendments and changes through Reaffirmation Notice , 1985


View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

EN
Additional Comments:
W/D NO S/S
Format
Details
Price (USD)
Print
In Stock
$60.00
Add to Cart

People Also Bought These:

SAE J639
ISO 55000
NETA MTS
ISO 55002

Product Details:

  • Revision: 1965 Edition, 1965
  • Published Date: January 1985
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASME International (ASME)
  • Page Count: 40
  • ANSI Approved: Yes
  • DoD Adopted: No

Description / Abstract:

OBJECT AND SCOPE

The object of the test shall be to determine various physical and chemical properties of dust. This Code provides procedures for determining these properties and defines the terminology to be used in stating these properties.

Modifications of the test procedures contained in this Code or the determination of special data outside the scope of this Code shall be made only after written agreement of all parties to the test regarding details of the test, methods of computation, and terminology to be used in reporting results - all of which shall be completely described in the test report.

This Code excludes the methods to be employed in obtaining the samples of dust to be tested. It shall be assumed that the samples of gas-borne dust taken from a duct shall be taken in accordance with the Test Code for Determining Dust Concentration in a Gas Stream (PTC 27-1957). It is recommended that samples should not be obtained from a large bulk of material in a hopper, silo, or from a similar location, If it is necessary to take samples from such a location due to the design of the particular unit being tested, the samples shall be taken by such procedures as will insure their being representative of the whole. In either case, the methods to be employed shall be defined in awritten agreement between all parties to the test.

Should the specific directions given in this Code for any particular measurement differ from those given in other ASME Power Test Codps for similar measurements, the instructions of this Code shalt prevail unless otherwise agreed by the parties to the test.