Hello. Sign In
Standards Store
ASTM A240/A240M Revision 15A, March 1, 2015
Complete Document
Active, Most Current
Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
Additional Comments: ALSO SEE ASTM A240/A240M (R)
Page Count:14
PDF :
$49.00 USD
In Stock
Print :
$54.00 USD
In Stock
ASTM BOS
IHS Standards Expert
IHS Knowledge Collections
This specification2 covers chromium, chromium-nickel, and chromium-manganese-nickel stainless steel plate, sheet, and strip for pressure vessels and for general applications including architectural, building, construction, and aesthetic applications.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This specification is expressed in both inch-pound and SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished in inch-pound units.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2 For ASME Boiler and Pressure Vessel Code applications see related Specification SA-240 in Section II of that Code.

*A Summary of Changes section appears at the end of this standard