Hello. Sign In
Standards Store

ASTM A307

2014 Edition, October 1, 2014

Complete Document

Standard Specification for Carbon Steel Bolts, Studs, and Threaded Rod 60 000 PSI Tensile Strength

Includes all amendments and changes through Editorial Change 1, May 2017


View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
ALSO SEE ASTM A307 (S)
Format
Details
Price (USD)
PDF
Single User
$46.00
Print
In Stock
$46.00
PDF + Print
In Stock
$78.20 You save 15%
Add to Cart

People Also Bought These:

ASME BPVC-IX
ASME BPVC-VIII-1
ASME BPVC-V
ASME B16.5

Product Details:

  • Revision: 2014 Edition, October 1, 2014
  • Published Date: May 2017
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 6
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This specification2 covers the chemical and mechanical requirements of two grades of carbon steel bolts and studs in sizes 14 in. through 4 in. The fasteners are designated by “Grade” denoting tensile strength and intended use, as follows:

A Threaded rod is not usually produced to Grade B, but can be when specified by the purchaser.

This specification does not cover requirements for machine screws, thread cutting/forming screws, mechanical expansion anchors or similar externally threaded fasteners.

Suitable nuts are covered in Specification A563. Unless otherwise specified, the grade and style of nut for each grade of fastener, of all surface finishes, shall be as follows:

A Nuts of other grades and styles having specified proof load stresses (Specification A563, Table 3) greater than the specified grade and style of nut are also suitable.

The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Supplementary Requirement S1 of an optional nature is provided, which describes additional restrictions to be applied when bolts are to be welded. It shall apply only when specified in the inquiry, order, and contract.

Terms used in this specification are defined in Terminology F1789 unless otherwise defined herein.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

For ASME Boiler and Pressure Vessel Code applications see related Specification SA-307 in Section II of that Code.

*A Summary of Changes section appears at the end of this standard