Hello. Sign In
Standards Store

ASTM A358

1985 Edition, March 29, 1985

Complete Document

Standard Specification for ELECTRIC-FUSION-WELDED AUSTENITIC CHROMIUM-NICKEL ALLOY STEEL PIPE FOR HIGH-TEMPERATURE SERVICE

Includes all amendments and changes through Change/Amendment , March 29, 1985


View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM A358/A358M

EN
Additional Comments:
W/D S/S BY ASTM A358/A358M
Format
Details
Price (USD)
PDF
Single User
$63.00
Print
In Stock
$63.00
Add to Cart

Product Details:

  • Revision: 1985 Edition, March 29, 1985
  • Published Date: March 29, 1985
  • Status: Superseded By:
  • Superseded By: ASTM A358/A358M
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 8
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This specification covers electric-fusion welded austenitic chromium-nickel alloy steel pipe suitable for corrosive or high-temperature service. or both. (Although no restrictions are placed on the sizes of pipe which may be furnished under this specification. commercial practice is commonly limited to sizes not less than NPS 8).

This specification covers nineteen grades of alloy steel as indicated in Table 1. The selection of the proper alloy and requirements for heat treatment shall be at the direction of the purchaser, dependent on the service conditions to be encountered.

Five classes of pipe are covered as follows:

Class 1-Pipe shall be double welded b processes employing filler metal in all passes and shall be completely radiographed.

Class 2 Pipe shall be double welded by processes employing filler metal in all passes. No radiography is required.

Class 3 Pipe shall be single welded by processes employing filler metal in all passes and shall be completely radiographed.

Class 4-Same as Class 3 except that the weld pass exposed to the inside pipe surface may be made without the addition of filler metal (see 5.2.2.1 and 5.2.2.).

Class 5 Pipe shall be double welded by processes employing filler metal in all passes and shall be spot radiographed. Supplementary requirements covering provisions ranging from additional testing to formalized procedures for manufacturing practice are provided.

Supplementary Requirements S1 through S6 are included as options to be specified when desired. The values stated in inch-pound units are to be regarded as the standard.