Hello. Sign In
Standards Store


2008 Edition, December 1, 2008

Complete Document

Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare

Includes all amendments and changes through Reapproval Notice , 2015

View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

Price (USD)
Single User
In Stock
PDF + Print
In Stock
$81.60 You save 15%
Add to Cart

People Also Bought These:

ISO 45001

Product Details:

  • Revision: 2008 Edition, December 1, 2008
  • Published Date: January 2015
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 7
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This specification covers the chemical and mechanical requirements of hexagon and square-head zinc-coated steel bolts and atmospheric corrosion-resistant bolts, in nominal thread diameters of 12, 58, 34 , 78 and 1 in. for use in the construction of transmission towers, substations, and similar steel structures. The various types of bolts covered in this specification are:

Type 0—Hot-dip zinc-coated bolts made of low or medium carbon steel.

Type 1—Hot-dip zinc-coated bolts made of medium carbon steel, quenched and tempered.

Type 2—Withdrawn in 2005.

Type 3—Bare (uncoated), quenched and tempered bolts made of weathering steel.

Annex A1 of this specification covers hot-dip zinccoated steel ladder bolts, step bolts, and support-equipment bolts.

Nuts and washers that are supplied under this specification that are hot-dip zinc coated shall be in accordance with 4.4.

Terms used in this specification are defined in Terminology F1789.

The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

The following safety hazards caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard