Hello. Sign In
Standards Store




ASTM A852/A852M

2003 Edition, April 10, 2003

Complete Document

Standard Specification for Quenched and Tempered Low-Alloy Structural Steel Plate with 70 ksi [485 MPa] Minimum Yield Strength to 4 in. [100 mm] Thick

Includes all amendments and changes through Reapproval Notice , 2007


View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

EN
Additional Comments:
W/D NO S/S
Format
Details
Price (USD)
PDF
Single User
$58.00
Print
In Stock
$58.00
PDF + Print
In Stock
$98.60 You save 15%
Add to Cart

Product Details:

  • Revision: 2003 Edition, April 10, 2003
  • Published Date: January 2007
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 3
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This specification covers quenched and tempered highstrength low-alloy structural steel plates for welded, riveted, or bolted construction. It is intended primarily for use in welded bridges and buildings where savings in weight, added durability, and good notch toughness are important. The atmospheric corrosion resistance of this steel in most environments is substantially better than that of carbon structural steels with or without copper addition (see Note 1). When properly exposed to the atmosphere, this steel can be used bare (unpainted) for many applications. Welding technique is of fundamental importance, and it is presupposed that the welding procedure will be suitable for the steel and the intended service. This specification is limited to material up to 4 in. [100 mm], inclusive, in thickness. See Appendix X3 of Specification A 6/A 6M for information on weldability.

NOTE 1—For methods of estimating the atmospheric corrosion resistance of low-alloy steels, see Guide G 101.

Plates produced under this specification are impact tested at a temperature not higher than 50°F [10°C].

The values stated in inch-pound units or SI units are to be regarded separately as standard.Within the text, the SI units are shown in brackets. The values stated in each item are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

*A Summary of Changes section appears at the end of this standard.