Hello. Sign In
Standards Store




ASTM A884/A884M

2014 Edition, May 1, 2014

Complete Document

Standard Specification for Epoxy-Coated Steel Wire and Welded Wire Reinforcement



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
ALSO SEE ASTM A884/A884M (S)
Format
Details
Price (USD)
PDF
Single User
$48.00
Print
In Stock
$48.00
PDF + Print
In Stock
$81.60 You save 15%
Add to Cart

People Also Bought These:

ASTM A240/A240M
SAE AS9101
ASME B18.27
SAE AS9100

Product Details:

  • Revision: 2014 Edition, May 1, 2014
  • Published Date: May 1, 2014
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 6
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This specification covers plain and deformed steel wire and plain and deformed steel welded wire reinforcement with protective epoxy coating. A Class A minimum coating thickness is required for wire and welded wire reinforcement intended for use in concrete and masonry. A Class B minimum coating thickness is required for wire and welded wire reinforcement intended for use in mechanically stabilized earth applications. A Type 1 coating is a fusion-bonded epoxy coating that has been formulated to be sufficiently flexible to allow bending of the coated wire or welded wire reinforcement. A Type 2 coating is a fusion-bonded epoxy coating that has not been designed to be sufficiently flexible to allow bending of the coated wire or welded wire reinforcement.

NOTE 1—The coating applicator is identified throughout this specification as the manufacturer.

This specification is applicable for orders in either inch-pound units (as Specification A884) or SI units (as Specification A884M).

The values stated in either inch-pound or SI units are to be regarded separately as standard.Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other except as specifically noted in Table 1. Combining values from the two systems may result in non-conformance with this specification.

This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard