Hello. Sign In
Standards Store

ASTM A928/A928M

2014 Edition, October 1, 2014

Complete Document

Standard Specification for Ferritic/Austenitic (Duplex) Stainless Steel Pipe Electric Fusion Welded with Addition of Filler Metal



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$45.00
Print
In Stock
$45.00
Add to Cart

People Also Bought These:

ASTM A480/A480M
ASTM A312/A312M
ASTM A240/A240M
ASTM A960/A960M

Product Details:

  • Revision: 2014 Edition, October 1, 2014
  • Published Date: October 1, 2014
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 7
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This specification covers electric-fusion-welded steel pipe suitable for corrosive service.

NOTE 1—The dimensionless designator NPS (nominal pipe size) has been substituted in this specification for traditional terms such as nominal diameter, size, and nominal size.

This specification covers grades of ferritic/austenitic steel as indicated in Table 1. The selection of the proper alloy and requirements for heat treatment shall be at the discretion of the purchaser, dependent on the service conditions to be encountered.

Five classes of pipe are covered as follows:

Class 1—Pipe shall be double welded by processes using filler metal in all passes and shall be radiographed completely.

Class 2—Pipe shall be double welded by processes using filler metal in all passes. No radiograph is required.

Class 3—Pipe shall be single welded by processes using filler metal in all passes and shall be radiographed completely.

Class 4—Same as Class 3, except that the weld pass exposed to the inside pipe surface is permitted to be made without the addition of filler metal (see 6.2.2.1 and 6.2.2.2).

Class 5—Pipe shall be double welded by processes using filler metal in all passes and shall be spot radiographed.

Supplementary requirements covering provisions ranging from additional testing to formalized procedures for manufacturing practice are provided. Supplementary Requirements S1 through S4 are included as options to be specified in the purchase order when desired.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the M designation of the specification is specified in the order.

*A Summary of Changes section appears at the end of this standard