Hello. Sign In
Standards Store
ASTM B335 2003 Edition, June 10, 2003
Complete Document
Active, Most Current
Standard Specification for Nickel-Molybdenum Alloy Rod
Includes all amendments and changes through Reapproval Notice , 2013
Page Count:4
PDF :
$40.00 USD
In Stock
Print  :
$40.00 USD
In Stock
This specification2 covers rod of nickel-molybdenum alloys (UNS N10001, N10665, N10675, N10629, and N10624)* as shown in Table 1, for use in general corrosive service.

The following products are covered under this specification:

Rods 516 to ¾ in. (7.94 to 19.05 mm) excl in diameter, hot or cold finished, solution annealed and pickled or mechanically descaled.

Rods ¾ to 3½ in. (19.05 to 88.9 mm) incl in diameter, hot or cold finished, solution annealed, ground or turned.

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

2 For ASME Boiler and Pressure Vessel Code applications see related Specification SB-335 in Section II of that Code.