Hello. Sign In
Standards Store




ASTM B439

2018 Edition, April 1, 2018

Complete Document

Standard Specification for Iron-Base Powder Metallurgy (PM) Bearings (Oil-Impregnated)



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$54.00
Print
In Stock
$54.00
PDF + Print
In Stock
$91.80 You save 15%
Add to Cart

People Also Bought These:

ASTM E18
QPL-AMS2644
SAE AMS2770
ASTM A240/A240M

Product Details:

  • Revision: 2018 Edition, April 1, 2018
  • Published Date: April 1, 2018
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 15
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This specification covers the requirements for porous iron-base metallic sleeve, flange, thrust, and spherical bearings that are produced from metal powders utilizing powder metallurgy (PM) technology and then impregnated with oil to supply operating lubrication.

Listed are the chemical, physical, and mechanical specifications for those standardized ferrous PM materials that have been developed specifically for the manufacture of selflubricating bearings.

This standard is a companion to Specification B438 that covers the requirements for porous oil-impregnated bronzebase bearings.

Typical applications for self-lubricating iron-base PM bearings are discussed in Appendix X1.

Commercial bearing dimensional tolerance data are shown in Appendix X2, while engineering information regarding installation and operating parameters of PM bearings is included in Appendix X3. Additional useful information on self-lubricating bearings can be found in MPIF Standard 35 (Bearings), ISO 5755 and the technical literature.2

Units—With the exception of the values for density and the mass used to determine density, for which the use of the g/cm3 unit is the long-standing practice of the PM industry, the values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not to be regarded as standard

The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

2 Machine Design Magazine, Vol 54, No. 14, June 17, 1982, pp. 130–142.

*A Summary of Changes section appears at the end of this standard