![]() ![]() ASTM D11202017 Edition, April 1, 2017Complete DocumentStandard Test Method for Boiling Point of Engine CoolantsDetail Summary
BUNDLE AND SAVE:
Item is contained in these product bundles ![]()
Additional Comments:
ALSO SEE ASTM D1120 (R)
PDF
Single User
$42.00
Print
In Stock
Need it fast? Ask for rush delivery.
Most backordered items can be rushed in from the publisher in as little as 24 hours. Some rush fees may apply. Contact your nearest IHS Markit Office to request rush delivery of any backordered item.
$42.00
PDF + Print
In Stock
Need it fast? Ask for rush delivery.
Most backordered items can be rushed in from the publisher in as little as 24 hours. Some rush fees may apply. Contact your nearest IHS Markit Office to request rush delivery of any backordered item.
$71.40
You save 15%
People Also Bought These:![]() ASTM D4452018 Edition, November 1, 2018STANDARD TEST METHOD FOR KINEMATIC VISCOSITY OF TRANSPARENT AND OPAQUE LIQUIDS (AND CALCULATION OF DYNAMIC VISCOSITY) ![]() ASTM E182019 Edition, January 1, 2019STANDARD TEST METHODS FOR ROCKWELL HARDNESS OF METALLIC MATERIALS ![]() STANDARD METHODS23rd Edition, 2017STANDARD METHODS FOR THE EXAMINATION OF WATER AND WASTEWATER Product Details:
![]() Description / Abstract:
This test method covers the determination of the equilibrium boiling point of engine coolants. The equilibrium boiling point indicates the temperature at which the sample will start to boil in a cooling system under equilibrium conditions at atmospheric pressure.
NOTE 1—Engine coolants may also be marketed in a ready-to-use form (prediluted). This test procedure is applicable to diluted solutions as well as to concentrates. NOTE 2—The procedure for obtaining a representative test sample of a coolant solution that contains an antileak additive is found in Practice D1176. The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. *A Summary of Changes section appears at the end of this standard ![]() |