Hello. Sign In
Standards Store

ASTM D1683

2007 Edition, July 1, 2007

Complete Document

Standard Test Method for Failure in Sewn Seams of Woven Apparel Fabrics



View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM D1683/D1683M

EN
Additional Comments:
W/D S/S BY ASTM D1683/D1683M
Format
Details
Price (USD)
PDF
Single User
$64.00
Print
In Stock
$64.00
PDF + Print
In Stock
$108.80 You save 15%
Add to Cart

People Also Bought These:

ISO 9073-10
ASTM D5733
ASTM D1683/D1683M
ASTM D5034

Product Details:

  • Revision: 2007 Edition, July 1, 2007
  • Published Date: July 1, 2007
  • Status: Superseded By:
  • Superseded By: ASTM D1683/D1683M
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 9
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method measures the sewn seam strength in woven fabrics by applying a force perpendicular to the sewn seams.

NOTE 1—The grab test procedure in Test Method D 5034 shall be used to determine any characteristic in fabric that can affect the measurement of sewn seam strength.

This test method is applicable to sewn seams obtained from a previously sewn article or seams sewn with fabric samples using either a specific seam assembly (see Table 1), or production seam assemblies.

This test method is used when a breaking force to rupture, a minimum elongation, or both are required to determine the sewn seam strength, seam slippage, or seam integrity of a particular fabric for a specified end use.

NOTE 2—This test method is used in conjunction with Test Method D 5034, which is used to measure breaking force and elongation of textile fabrics. Sewn seams in woven fabrics can fail due to rupture, slippage, or any combination thereof. Rupture can be further categorized as failure or fabric, or sewing thread, or seam slippage.

This test method does not predict actual wear performance of a seam.

The values stated in either acceptable metric units (SI) or in other units shall be regarded separately as standard. The values expressed in each system may not be exact equivalents; therefore each system must be used independently of the other, without combining values in any way.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.