Hello. Sign In
Standards Store

ASTM D2274

2014 Edition, December 1, 2014

Complete Document

Standard Test Method for Oxidation Stability of Distillate Fuel Oil (Accelerated Method)



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
IP DESIGNATION: 388/97 * ALSO SEE ASTM D2274 (R)
Format
Details
Price (USD)
PDF
Single User
$45.00
Print
In Stock
$45.00
PDF + Print
In Stock
$76.50 You save 15%
Add to Cart

People Also Bought These:

ASTM D445
ASTM D1322
ASTM D93
ASTM D974

Product Details:

  • Revision: 2014 Edition, December 1, 2014
  • Published Date: December 1, 2014
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 6
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This test method covers the measurement of the inherent stability of middle distillate petroleum fuels under specified oxidizing conditions at 95 °C.

NOTE 1—Fuels used in establishing the precision measures for this test method were described as gas oil, diesel fuel, No. 2 heating oil, and DFM, a Navy distillate fuel suitable for diesels, boilers, and gas turbines. (The term DFM is no longer used when referring to fuel meeting MIL-F-16884 requirements; rather it is called F76 as it conforms to NATO F76 requirements.) While the test method may be used for fuels outside the range of these fuels, the precision measures may not apply.

This test method is not applicable to fuels containing residual oil. This test method has not been validated for testing biodiesel, such as meeting Specification D6751 or blends of middle distillates and biodiesel, such as meeting Specification D7467, or both. Test Method D7462 has been determined to be suitable for testing B100 and all blends of middle distillates and biodiesel.

NOTE 2—No. 1 and No. 2 grades in Specifications D396 or D975 currently allow up to 5 % biodiesel meeting Specification D6751. Samples containing biodiesel can result in partial dissolution or compromise of the membrane filter and give erroneous results.

The values given in SI units are to be regarded as the standard. The values in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard