Hello. Sign In
Standards Store

ASTM D2291

2009 Edition, September 1, 2009

Complete Document

Standard Practice for Fabrication of Ring Test Specimens for Glass-Resin Composites

Includes all amendments and changes through Change/Amendment , September 1, 2009


View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM D2291/D2291M

EN
Additional Comments:
W/D S/S BY ASTM D2291/D2291M
Format
Details
Price (USD)
PDF
Single User
$56.00
Print
In Stock
$56.00
Add to Cart

People Also Bought These:

IEC 60825-1
IPC-6013
ASTM D2240
IEC 60533

Product Details:

  • Revision: 2009 Edition, September 1, 2009
  • Published Date: September 1, 2009
  • Status: Superseded By:
  • Superseded By: ASTM D2291/D2291M
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This practice is intended for use in the fabrication of ring-type test specimens to be used in the evaluation of the mechanical properties of reinforcement and resins in a composite structure. The practice outlines the steps in the preparation of the test specimens, including the final specimen machining where applicable. Four final ring configurations are included.

The values stated in either SI units of inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 1—There is no known ISO equivalent to this practice.

*A Summary of Changes section appears at the end of this standard.