Hello. Sign In
Standards Store

ALERT: Due to a water main break at our production facility, hardcopy orders may be delayed. We expect to be back to normal operation
by May 30. For the inconvenience, we have set up a promotion code for 15% off any hardcopy orders while we complete repairs.
Enter IHSM at checkout to receive your discount. Please contact your local
sales office to discuss other delivery options.
PDF delivery orders will not be impacted.

ASTM D2585

1968 Edition, September 9, 1968

Complete Document

Standard Test Method for Preparation and Tension Testing of Filament-Wound Pressure Vessels

Includes all amendments and changes through Editorial Change 1, April 1990

View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

Additional Comments:
Price (USD)
Single User
In Stock
PDF + Print
In Stock
$108.80 You save 15%
Add to Cart

People Also Bought These:

ASTM A240/A240M
ASTM A479/A479M
ISO 6976
SAE J1453-2

Product Details:

  • Revision: 1968 Edition, September 9, 1968
  • Published Date: April 1990
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 5
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

1. Scope

1.1 This test method covers the determination of the apparent tensile parameters of filament-wound pressure vessels. The tensile parameters are predicted on defined conditions of geometry, fabrication, and test. This test method also describes the details necessary to wind either inplane or helical winding patterns. The two general procedures used in preparing the specimens are:

Procedure A, winding on a washout-type mandrel, and

Procedure B, winding on a rubber-lined steel mandrel.

1.2 Both procedures have been used successfully for design data generation and quality control by various agencies.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.

1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.