Hello. Sign In
Standards Store

ASTM D2684

2010 Edition, August 1, 2010

Complete Document

Standard Test Method for Permeability of Thermoplastic Containers to Packaged Reagents or Proprietary Products

Includes all amendments and changes through Change/Amendment , August 1, 2010


View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM D2684/D2684M

EN
Additional Comments:
W/D S/S BY ASTM D2684/D2684M
Format
Details
Price (USD)
PDF
Single User
$63.00
Print
In Stock
$63.00
PDF + Print
In Stock
$107.10 You save 15%
Add to Cart

People Also Bought These:

ASTM E595
BS EN 15502-1
CSA C22.2 NO 29
SAA AS 5263.0

Product Details:

  • Revision: 2010 Edition, August 1, 2010
  • Published Date: August 1, 2010
  • Status: Superseded By:
  • Superseded By: ASTM D2684/D2684M
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 5
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method covers procedures for determining the permeability of thermoplastic containers to packaged reagents or proprietary products under specified conditions of exposure. The exposures used are intended to simulate the normal and elevated temperature-storage conditions that might be encountered in end-use application.

This test method is applicable only to those types of containers designed to allow positive, leakproof closure.

Two procedures are provided:

Procedure A is specific to testing only with a standard design container. This procedure provides for determinations of rate of weight loss (or gain) and for calculation of a permeability factor.

Procedure B applies to tests of all other container designs. Permeability data by this procedure are expressed only in terms of rate of weight loss (or gain) for the particular container tested.

The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

NOTE 1—There is no known ISO equivalent to this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard.