Hello. Sign In
Standards Store

ASTM D2710

2009 Edition, October 1, 2009

Complete Document

Standard Test Method for Bromine Index of Petroleum Hydrocarbons by Electrometric Titration

Includes all amendments and changes through Reapproval Notice , 2013


View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
IP DESIGNATION: 299/92 * ALSO SEE ASTM D2710 (R)
Format
Details
Price (USD)
PDF
Single User
$40.00
Print
In Stock
$40.00
PDF + Print
In Stock
$68.00 You save 15%
Add to Cart

People Also Bought These:

ASTM D1322
ASTM E313
ASTM D445
ASTM D93

Product Details:

  • Revision: 2009 Edition, October 1, 2009
  • Published Date: January 2013
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method covers the determination of the amount of bromine-reactive material in petroleum hydrocarbons and is thus a measure of trace amounts of unsaturates in these materials. It is applicable to materials having bromine indexes below 1000.

This test method is applicable only to essentially olefinfree hydrocarbons or mixtures that are substantially free from material lighter than isobutane and have a distillation end point under 288°C (550°F).

NOTE 1—This procedure has been cooperatively tested on materials with bromine indexes in the range from 100 to 1000. These materials include petroleum distillates such as straight-run and hydrocracked naphtha, reformer feed, kerosine, and aviation turbine fuel.

NOTE 2—Materials with bromine index greater than 1000 should be tested for bromine number using Test Method D1159/IP 130.

NOTE 3—Bromine index of industrial aromatic hydrocarbons should be determined using Test Method D1492 or D5776. The subcommittee is currently examining ways to achieve more consistent end point values.

The values stated in SI units are to be regarded as standard. The values stated in inch-pound units are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.