Hello. Sign In
Standards Store

ASTM D3362

2005 Edition, May 15, 2005

Complete Document

Standard Test Method for Purity of Acrylate Esters by Gas Chromatography



View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

EN
Additional Comments:
W/D NO S/S
Format
Details
Price (USD)
PDF
Single User
$56.00
Print
In Stock
$56.00
Add to Cart

People Also Bought These:

ANSI A156.18
ASTM B117
ASTM D1044
ASTM D2204

Product Details:

  • Revision: 2005 Edition, May 15, 2005
  • Published Date: May 15, 2005
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

(Footnote *)

This test method covers the determination of the purity of acrylate, ethyl acrylate, n-butyl acrylate, and 2-ethylhexyl acrylate by gas chromatography and, in addition, provides a means for measuring certain impurities such as alcohols and other esters. Water and acidity are measured by other appropriate ASTM procedures and the results are used to normalize the chromatographic values.

The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

For hazard information and guidance, see the supplier's Material Safety Data Sheet.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.

Footnote * - A Summary of Changes section appears at the end of this standard.