Hello. Sign In
Standards Store

ASTM D3419

2012 Edition, April 1, 2012

Complete Document

Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$40.00
Print
In Stock
$40.00
Add to Cart

People Also Bought These:

ASTM A240/A240M
SAE AMS7718
ASTM A479/A479M
ASME BPVC-IX

Product Details:

  • Revision: 2012 Edition, April 1, 2012
  • Published Date: April 1, 2012
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This practice covers the general principles to be followed when injection molding test specimens of thermosetting materials. It is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and in the reporting of those conditions. The exact molding conditions will vary from material to material, and should become part of the material specification or be agreed upon between the purchaser and the supplier.

NOTE 1—The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting lower-viscosity non-Newtonian flow.

The values stated in SI units are to be regarded as standard. The values given in brackets are for information only.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

This practice assumes the use of reciprocating screw injection molding machines.

NOTE 2—This standard is similar in content (but not technically equivalent) to ISO 10724: 1994(E).