Hello. Sign In
Standards Store




ASTM D3763

2018 Edition, November 1, 2018

Complete Document

Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$48.00
Print
In Stock
$48.00
PDF + Print
In Stock
$81.60 You save 15%
Add to Cart

People Also Bought These:

ASTM D790
GMW14650
ASTM B117
GMW3059

Product Details:

  • Revision: 2018 Edition, November 1, 2018
  • Published Date: November 1, 2018
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 10
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method covers the determination of puncture properties of rigid plastics over a range of test velocities.

Test data obtained by this test method are relevant and appropriate for use in engineering design.

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

NOTE 1—This standard and ISO 6603-2 address the same subject matter, but differ in technical content. The technical content and results shall not be compared between the two test methods.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

*A Summary of Changes section appears at the end of this standard