Hello. Sign In
Standards Store




ASTM D3945

1993 Edition, March 15, 1993

Complete Document

Standard Test Methods for Shear Stability of Polymer-Containing Fluids Using a Diesel Injector Nozzle



View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM D6278

EN
Additional Comments:
W/D S/S BY ASTM D6278
Format
Details
Price (USD)
PDF
Single User
$75.00
Print
In Stock
$75.00
PDF + Print
In Stock
$127.50 You save 15%
Add to Cart

Product Details:

  • Revision: 1993 Edition, March 15, 1993
  • Published Date: March 15, 1993
  • Status: Superseded By:
  • Superseded By: ASTM D6278
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 11
  • ANSI Approved: Yes
  • DoD Adopted: No

Description / Abstract:



1. Scope

1.1 These test methods measure the percent viscosity loss at 100°C of polymer-containing fluids when evaluated by either of two diesel injector apparatus procedures. Procedure A uses European Diesel Injector Test Equipment and Procedure B uses Fuel Injector Shear Stability Test (FISST) equipment. The viscosity loss reflects polymer degradation due to shear at the nozzle.

NOTE 1--ASTM Test Method D 2603 has been used for similar evaluation of this property. It has many of the same limitations as indicated in the significance statement. No detailed attempt has been undertaken to correlate the results by the sonic and the diesel injector methods. Equipment and replacement parts are no longer available for Test Method D 2603.

NOTE 2--Procedure A of this method uses test apparatus as defined in CEC L-14-A-79, IP 294/76 and DIN 51382. The operational procedure is different on four specific points. Procedure A evaluates hydraulic-type fluids at 30 cycles, with viscosities measured at 100°C. Results are reported for single determinations. No equipment severity correction factor is used to adjust results.

1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.