Hello. Sign In
Standards Store




ASTM D4536

1996 Edition, 1996

Complete Document

Standard Test Method for High-Volume Sampling for Solid Particulate Matter and Determination of Particulate Emissions



View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM D6331

EN
Additional Comments:
W/D S/S BY ASTM D6331
Format
Details
Price (USD)
PDF
Single User
$75.00
Print
In Stock
$75.00
PDF + Print
In Stock
$127.50 You save 15%
Add to Cart

Product Details:

  • Revision: 1996 Edition, 1996
  • Published Date: April 10, 1996
  • Status: Superseded By:
  • Superseded By: ASTM D6331
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 10
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:



1. Scope

1.1 This test method can be used to estimate the particulate matter concentration in stationary source stacks.

1.2 With the nozzle sizes specified herein, the method can be used for stack stream velocities from approximately 4 to 45 m/s (800 to 8 000 ft/min).

1.3 Particulate matter present in a gaseous phase at the filtration temperature will not be collected. If significant quantities of condensible particulate matter are expected, this test method may not be the method of choice. If the temperature of the sampled gas at the filter is below the stream dewpoint this test method will not work. If moisture is expected to condense between the filter and the orifice, this test method is not applicable unless a moisture collection device is placed immediately upstream of the orifice and the sampling rate is adjusted for the volume of gas that condensed upstream of the orifice.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.