Hello. Sign In
Standards Store
ASTM D4873 2015 Edition, February 15, 2015
Complete Document
Standard Guide for Identification, Storage, and Handling of Geosynthetic Rolls and Samples
Includes all amendments and changes through Change/Amendment , February 15, 2015
Additional Comments: W/D S/S BY ASTM D4873/D4873M
Page Count:5
PDF :
$63.00 USD
In Stock
Print  :
$63.00 USD
In Stock
This guide provides guidelines for the identification and packaging of rolled geosynthetics by the manufacturer and for the handling and storage of geosynthetics by the end user. This guide is not to be considered as all encompassing since each project involving geosynthetics presents its own challenges and special conditions. Geosynthetic samples are often taken at manufacturer, supplier, or at the job site primarily for the purpose of conformance testing and verification. These samples should be properly labeled for identification purposes.

This guide is intended to aid manufacturers, suppliers, purchasers, and users of geosynthetics for identification, handling, and storage.

This guide is not applicable for factory fabricated panels due to a different set of identifications for the panel by the fabricator. For Fabricated Geomembrane Panels, refer to Guide D7865.

This guide is not intended for Geosynthetic Clay Liners. For GCL's, refer to Guide D5888.

This guide is also applicable to geosynthetic samples.

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.