Hello. Sign In
Standards Store




ASTM D4883

2018 Edition, November 1, 2018

Complete Document

Standard Test Method for Density of Polyethylene by the Ultrasound Technique

Includes all amendments and changes through Reinstatement Notice , November 2018


View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$42.00
Print
In Stock
$42.00
PDF + Print
In Stock
$71.40 You save 15%
Add to Cart

People Also Bought These:

ASTM E2893
ISO 9001
ASCE 21-13
DS/EN ISO 14644-1

Product Details:

  • Revision: 2018 Edition, November 1, 2018
  • Published Date: November 2018
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method covers the determination of the density of polyethylene through the utilization of ultrasound equipment.

This test method is based on the distinct behaviors of the amorphous and crystalline phases of polyethylene in response to ultrasound. Polyethylene shall be viewed as a composite structure where high-density crystalline regions are connected by lower-density amorphous material. The ratio of crystalline to amorphous material determines the final density of the material. The amorphous and crystalline phases exhibit very distinct behaviors with regard to the propagation of sound waves. The propagation characteristics in the composite will depend on the relative amount of the two phases (the degree of crystallinity).

Inorganic materials increase density as measured by Test Methods D792 and D1505, but they have little or no effect on ultrasonic density. The ultrasonic measurement is basically a base resin density.

The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

NOTE 1—There is no known ISO equivalent to this standard.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

*A Summary of Changes section appears at the end of this standard