Hello. Sign In
Standards Store

ASTM D5028

2017 Edition, July 15, 2017

Complete Document

Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$41.00
Print
In Stock
$41.00
PDF + Print
In Stock
$69.70 You save 15%
Add to Cart

People Also Bought These:

ASTM D445 + REDLINE
ASME BPVC-IX
AASHTO/AWS D1.5M/D1.5
ASTM E18 + REDLINE

Product Details:

  • Revision: 2017 Edition, July 15, 2017
  • Published Date: July 15, 2017
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method covers determination of curing parameters of pultrusions resins by differential scanning calorimetry.

This test method is applicable to pultrusion resin solutions with adequate initiator(s).

The normal operating temperature range is from 0 to 200°C.

NOTE 1—Resin systems that do not form an adequate baseline are not covered by this test method.

Computer or electronic based instruments or data treatment equivalent to this practice are suitable for use.

The values stated in SI units are to be regarded as standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 1.

NOTE 2—There is no known ISO equivalent to this standard.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

*A Summary of Changes section appears at the end of this standard