Hello. Sign In
Standards Store

ASTM D5453

2016 Edition, April 15, 2016

Complete Document

Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Spark Ignition Engine Fuel, Diesel Engine Fuel, and Engine Oil by Ultraviolet Fluorescence

Includes all amendments and changes through Editorial Change 1, June 2016


View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
ALSO SEE ASTM D5453 (R)
Format
Details
Price (USD)
PDF
Single User
$51.00
Print
In Stock
$51.00
Add to Cart

People Also Bought These:

ANSI/ISEA Z358.1
ASTM D86
DNV-OS-F101
ASTM D3241

Product Details:

  • Revision: 2016 Edition, April 15, 2016
  • Published Date: June 2016
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 11
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This test method covers the determination of total sulfur in liquid hydrocarbons, boiling in the range from approximately 25 °C to 400 °C, with viscosities between approximately 0.2 cSt and 20 cSt (mm2/s) at room temperature.

Three separate interlaboratory studies (ILS) on precision, and three other investigations that resulted in an ASTM research report, have determined that this test method is applicable to naphthas, distillates, engine oil, ethanol, Fatty Acid Methyl Ester (FAME), and engine fuel such as gasoline, oxygen enriched gasoline (ethanol blends, E-85, M-85, RFG), diesel, biodiesel, diesel/biodiesel blends, and jet fuel. Samples containing 1.0 mg ⁄kg to 8000 mg ⁄kg total sulfur can be analyzed (Note 1).

NOTE 1—Estimates of the pooled limit of quantification (PLOQ) for the precision studies were calculated. Values ranged between less than 1.0 mg ⁄kg and less than 5.0 mg/kg (see Section 8 and 15.1).

This test method is applicable for total sulfur determination in liquid hydrocarbons containing less than 0.35 % (m ⁄m) halogen(s).

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For warning statements, see 3.1, 6.3, 6.4, Section 7, and 8.1.

*A Summary of Changes section appears at the end of this standard