Hello. Sign In
Standards Store

ASTM D5467

1997 Edition, October 10, 1997

Complete Document

Standard Test Method for Compressive Properties of Unidirectional Polymer Matrix Composite Materials Using a Sandwich Beam



View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM D5467/D5467M

EN
Additional Comments:
W/D S/S BY ASTM D5467/D5467M
Format
Details
Price (USD)
PDF
Single User
$63.00
Print
In Stock
$63.00
Add to Cart

Product Details:

  • Revision: 1997 Edition, October 10, 1997
  • Published Date: October 10, 1997
  • Status: Superseded By:
  • Superseded By: ASTM D5467/D5467M
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 9
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:



1. Scope

1.1 This test method covers the in-plane compressive properties of polymer matrix composite materials reinforced by high-modulus fibers in a sandwich beam configuration. The composite material forms are limited to continuous-fiber composites of unidirectional orientation. This test procedure introduces compressive load into a thin skin bonded to a thick honeycomb core with the compressive load transmitted into the sample by subjecting the beam to four-point bending.

1.2 This procedure is applicable primarily to laminates made from prepreg or similar product forms. Other product forms may require deviations from the test method.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pounds units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

NOTE 1--Additional procedures for determining compressive properties of polymer matrix composites may be found in Test Methods D 3410/D 3410M and D 695.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.