Hello. Sign In
Standards Store

ASTM D5625

1997 Edition, December 10, 1997

Complete Document

Standard Test Method for Measuring Length, Width, and Squareness of Sheeted Paper and Paper Products

Includes all amendments and changes through Reapproval Notice , 2002

View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

Additional Comments:
Price (USD)
Single User
In Stock
PDF + Print
In Stock
$96.90 You save 15%
Add to Cart

Product Details:

  • Revision: 1997 Edition, December 10, 1997
  • Published Date: January 2002
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 3
  • ANSI Approved: Yes
  • DoD Adopted: No

Description / Abstract:

This test method determines the average length, width, and squareness of sheets of paper. It may also be used to determine the difference between consecutive sheets in a lot of paper. It is especially useful with printing and writing papers which have been cut to specific sizes. The procedure is applicable to a wide range of sheet dimensions, including dimensions as small as 1.6 in. (41 mm) to as large as 60.2 in. (1530 mm). While not the subject of this test method, the equipment described may be used to determine uniformity of hole punching and various process variables related to the cutting of sheeting papers.

The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.