Hello. Sign In
Standards Store




ASTM E1030

2005 Edition, December 1, 2005

Complete Document

Standard Test Method for Radiographic Examination of Metallic Castings

Includes all amendments and changes through Reapproval Notice , 2011


View Abstract
Product Details
Document History

Detail Summary

Superseded By: ASTM E1030/E1030M

EN
Additional Comments:
W/D S/S BY ASTM E1030/E1030M
Format
Details
Price (USD)
PDF
Single User
$75.00
Print
In Stock
$75.00
PDF + Print
In Stock
$127.50 You save 15%
Add to Cart

People Also Bought These:

ASTM E8/E8M
ASTM E29
ISO 14708-1
IEC 60695-10-2

Product Details:

  • Revision: 2005 Edition, December 1, 2005
  • Published Date: January 2011
  • Status: Superseded By:
  • Superseded By: ASTM E1030/E1030M
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 11
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method2 provides a uniform procedure for radiographic examination of metallic castings using radiographic film as the recording medium.

Due to the many complex geometries and part configurations inherent with cast products, it is necessary to recognize potential limitations associated with obtaining complete radiographic coverage on castings. Radiography of areas where geometry or part configuration does not allow achievement of complete coverage with practical radiographic methods shall be subject to mutual agreements between purchaser and supplier. The use of alternative nondestructive methods for areas that are not conducive to practical radiography shall also be specifically agreed upon between purchaser and supplier.

The radiographic method is highly sensitive to volumetric discontinuities that displace a detectable volume of cast material. Discontinuities that do not displace an appreciable volume of material, however, such as cracks or other planartype indications, may not be detected with radiography unless the radiation beam is coincidentally aligned with the planar orientation of the discontinuity. In view of this limitation, it may be considered appropriate to use the radiographic method in conjunction with additional nondestructive methods that maintain reliable detection capabilities for these types of discontinuities. The use of additional methods shall be specifically agreed upon between the purchaser and supplier.

The radiographic techniques stated herein provide adequate assurance for defect detectability; however, it is recognized that, for special applications, specific techniques using more or less stringent requirements may be required than those specified. In these cases, the use of alternate radiographic techniques shall be as agreed upon between purchaser and supplier (also see Section 5).

The values stated in inch-pound units are to be regarded as standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2 For ASME Boiler and Pressure Vessel Code applications see related Test Method SE-1030 in Section II of that Code.