Hello. Sign In
Standards Store

ASTM E1315

1993 Edition, September 15, 1993

Complete Document

Standard Practice for Ultrasonic Examination of Steel with Convex Cylindrically Curved Entry Surfaces

Includes all amendments and changes through Reapproval Notice , 2002


View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

EN
Additional Comments:
W/D 2007 NO S/S
Format
Details
Price (USD)
PDF
Single User
$57.00
Print
In Stock
$57.00
PDF + Print
In Stock
$96.90 You save 15%
Add to Cart

Product Details:

  • Revision: 1993 Edition, September 15, 1993
  • Published Date: January 2002
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: Yes
  • DoD Adopted: No

Description / Abstract:

This practice describes the selection of single-element hard-face ultrasonic search units for which flat-entry-surface reference blocks can be used for examination of steel with convex cylindrically curved entry surfaces.

The scope of this practice includes the determination of search unit characteristics and radius of surface curvature of the material for which no gain correction is required, or, if a larger search unit is used, the computation of the additional gain required to allow standardization with a flat reference block and examination on a curved surface.

This practice is intended for use during contact examination of convexly curved steel material using round flat face, piezoelectric search units for longitudinal ultrasonic wave generation in the frequency range from 1 to 10 MHz.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.