Hello. Sign In
Standards Store




ASTM E1399/E1399M

97th Edition, November 10, 1997

Complete Document

Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems

Includes all amendments and changes through Reapproval Notice , 2017


View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$46.00
Print
In Stock
$46.00
PDF + Print
In Stock
$78.20 You save 15%
Add to Cart

People Also Bought These:

ASTM D1970/D1970M
ASTM C665
ASTM E119
ASTM E84

Product Details:

  • Revision: 97th Edition, November 10, 1997
  • Published Date: January 2017
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 6
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method covers testing procedures for architectural joint systems. This test method is intended for the following uses for architectural joint systems:

To verify movement capability information supplied to the user by the producer,

To standardize comparison of movement capability by relating it to specified nominal joint widths,

To determine the cyclic movement capability between specified minimum and maximum joint widths without visual deleterious effects, and

To provide the user with graphic information, drawings or pictures in the test report, depicting them at minimum, maximum, and nominal joint widths during cycling.

This test method is intended to be used only as part of a specification or acceptance criterion due to the limited movements tested.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.