Hello. Sign In
Standards Store




ASTM E604

2018 Edition, June 1, 2018

Complete Document

Standard Test Method for Dynamic Tear Testing of Metallic Materials



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$48.00
Print
In Stock
$48.00
PDF + Print
In Stock
$81.60 You save 15%
Add to Cart

People Also Bought These:

ASTM E45
ASTM E8/E8M
ASTM A1011/A1011M
ASTM A370

Product Details:

  • Revision: 2018 Edition, June 1, 2018
  • Published Date: June 1, 2018
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 9
  • ANSI Approved: No
  • DoD Adopted: Yes

Description / Abstract:

This test method covers the dynamic tear (DT) test using specimens that are 3⁄16 in. to 5⁄8 in. (5 mm to 16 mm) inclusive in thickness.

This test method is applicable to materials with a minimum thickness of 3⁄16 in. (5 mm).

The pressed-knife procedure described for sharpening the notch tip generally limits this test method to materials with a hardness level less than 36 HRC. NOTE 1—The designation 36 HRC is a Rockwell hardness number of 36 on Rockwell C scale as defined in Test Methods E18.

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

*A Summary of Changes section appears at the end of this standard