Hello. Sign In
Standards Store
ASTM E949 1988 Edition, March 25, 1988
Complete Document
Not Active, See comments below
Standard Test Method for Total Moisture in a Refuse-Derived Fuel Laboratory Sample
Includes all amendments and changes through Reapproval Notice , 2004
Additional Comments: W/D NO S/S
Page Count:4
$56.00 USD
In Stock
Print  :
$56.00 USD
In Stock
This test method covers the measurement of the total moisture in RDF as it exists at the time it is sampled. Because of its empirical nature, strict adherence to test procedures are required for valid results. The standard is available to producers, vendors, and consumers as a total, two-stage moisture method.

Since RDF can vary from extremely wet (water saturated) to relatively dry, special emphasis must be placed on sampling, sample preparation, and the method of determination.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statement, see Section 7.