Hello. Sign In
Standards Store

ASTM F1067

1992 Edition, January 15, 1992

Complete Document

Standard Test Method for Determining the Performance of a Petroleum Product Filter Cartridge Using a Single-Pass Constant Rate Procedure

View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

Additional Comments:
Price (USD)
Single User
In Stock
PDF + Print
In Stock
$98.60 You save 15%
Add to Cart

Product Details:

  • Revision: 1992 Edition, January 15, 1992
  • Published Date: January 15, 1992
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

1. Scope

1.1 This test method covers filter cartridges where the petroleum product feed stream flows at a constant flow rate, makes one pass through the filter cartridge and is not recirculated unfiltered back to the feed tank.

1.2 The flow rate, flow direction, and change out differential pressure for the cartridge will be specified by the manufacturer. These criteria will be included in the performance report.

1.3 The physical properties, including viscosity of the liquid used in the test, should be representative of that found in the end-use application intended for the filter cartridge.

1.4 AC fine test dust will be used as the particle challenge.

1.5 Expressions of filtration performance are in the form of filtration ratios and filtration efficiencies derived from particle-size distributions of test dust acquired by an approved method.

1.6 Filter life is expressed as total mass of challenging contaminant necessary to reach specified change out maximum differential pressure.

1.7 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.