Hello. Sign In
Standards Store
ASTM F1199 1988 Edition, December 30, 1988
Complete Document
Active, Most Current
Standard Specification for Cast (All Temperatures and Pressures) and Welded Pipe Line Strainers (150 psig and 150 Degrees F Maximum)
Includes all amendments and changes through Reapproval Notice , 2015
Page Count:3
$40.00 USD
In Stock
Print  :
$40.00 USD
In Stock
This specification covers all cast strainers and welded strainers in services up to 150 psig and 150°F (1 MPa and 65°C). For welded strainers used in services above 150 psig and 150°F, see Specification F1200.

This standard provides the minimum requirements for the design, fabrication, rating, marking, and testing of cast and welded pipe line strainers for services above 0°F (−18°C).

Strainers manufactured to this specification are acceptable for use in the marine environment.

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.