Hello. Sign In
Standards Store

ASTM F1589

1995 Edition, March 15, 1995

Complete Document

Standard Test Method for Determination of the Critical Pressure for Rapid Crack Propagation in Plastic Pipe

Includes all amendments and changes through Reapproval Notice , 2001


View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

EN
Additional Comments:
W/D NO S/S
Format
Details
Price (USD)
PDF
Single User
$56.00
Print
In Stock
$56.00
PDF + Print
In Stock
$95.20 You save 15%
Add to Cart

Product Details:

  • Revision: 1995 Edition, March 15, 1995
  • Published Date: January 2001
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 3
  • ANSI Approved: Yes
  • DoD Adopted: No

Description / Abstract:

This test method determines the minimum internal air pressure at which rapid crack propagation (RCP) can be sustained along a section of plastic pipe. This is termed the critical pressure.

This technique achieves steady state RCP in a small specimen by restraining the decompression which normally accompanies fracture, and therefore indicates a lower critical pressure than that measured on the same pipe using full-scale tests. This test method has been called "Small Scale Steady State" or S4.

This test method was developed for polyethylene pipe, and has been shown to correlate with the full-scale RCP test method. The user should determine if it is applicable to other plastic piping methods.

The values stated in inch-pound units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.