Hello. Sign In
Standards Store

ASTM F2517

2017 Edition, October 1, 2017

Complete Document

Standard Specification for Determination of Child Resistance of Portable Fuel Containers for Consumer Use

View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

Price (USD)
Single User
In Stock
PDF + Print
In Stock
$78.20 You save 15%
Add to Cart

People Also Bought These:

ASME B20.1
ASME P30.1

Product Details:

  • Revision: 2017 Edition, October 1, 2017
  • Published Date: October 1, 2017
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 8
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This specification establishes recognized requirements for determining the child resistance of portable gasoline, kerosene, and diesel containers intended for use by consumers. This specification does not cover single-trip prepackaged containers.

“Containers” as defined herein means the receptacle for gasoline, kerosene, or diesel fuel, including its spouts, retrofit spouts, caps and other closure mechanisms and components intended for use by consumers. If any such spout, retrofit spout, cap or other closure mechanism is sold separately for use with or on portable gasoline, kerosene, or diesel receptacles, it must be designed to and function in compliance with this specification when installed on any such receptacle.

This specification includes gas/oil mixtures as commonly used for two-cycle engines.

This specification includes single- and multicompartment containers.

This standard addresses the effectiveness of the child resistance (CR) device only after closure cycling, but does not address closure effectiveness:

When at high or low temperatures,

After thermal aging of polymers,

After exposure to sunlight,

After exposure to intended fuels, and

After physical abuses, such as drops or impacts.

NOTE 1—Please see Appendix X2 for additional information on these exemptions.

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.