ASTM F405 2013 Edition, August 1, 2013
Standard Specification for Corrugated Polyethylene (PE) Pipe and Fittings
Includes all amendments and changes through Change/Amendment , August 1, 2013
Additional Comments: W/D S/S BY ASTM F667/F667M
Published By:ASTM International (ASTM)
This specification covers requirements and test methods for materials, marking dimensions, workmanship, elongation, brittleness, pipe stiffness, and perforations for corrugated polyethylene (PE) pipe and fittings in nominal sizes of 3 to 6 in., inclusive.
The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
NOTE 1—Along with sizes 3 to 6 in. covered in this specification, sizes 4 to 24 in. are described in Specification F667.
The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
The following precautionary caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
*A Summary of Changes section appears at the end of this standard