Hello. Sign In
Standards Store
ASTM F468M 2006 Edition, May 1, 2006
Complete Document
Active, Most Current
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Includes all amendments and changes through Reapproval Notice , 2012
Page Count:11
PDF :
$51.00 USD
In Stock
Print  :
$51.00 USD
In Stock
This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.

Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F467M. Nuts shall be of the same alloy group as the fastener on which they are used and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

NOTE 1—This specification is the metric companion of Specification F468.

*A Summary of Changes section appears at the end of this standard.