Hello. Sign In
Standards Store

ASTM F690

1986 Edition, 1986

Complete Document

Standard Practice for Underground Installation of Thermoplastic Pressure Piping Irrigation Systems

Includes all amendments and changes through Editorial Change 2, December 2004


View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

EN
Additional Comments:
W/D NO S/S
Format
Details
Price (USD)
PDF
Single User
$63.00
Print
In Stock
$63.00
PDF + Print
In Stock
$107.10 You save 15%
Add to Cart

Product Details:

  • Revision: 1986 Edition, 1986
  • Published Date: December 2004
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 6
  • ANSI Approved: Yes
  • DoD Adopted: No

Description / Abstract:

This practice covers general and basic procedures related to the proper installation of thermoplastic, flexible, pressure piping, 36 in. nominal size and smaller, for underground irrigation systems. Because there is considerable variability in end-use requirements, soil conditions, and thermoplastic piping characteristics, it is the intent of this practice to outline general objectives and basics of proper installation and to provide pertinent references, rather than to prescribe detailed installation procedures.

This practice should not be used for installing thermoplastic underground sewer, drain, potable water, conduit, or gas service piping.

The values stated in inch-pound units are to be regarded as the standard. Values in parentheses are mathematical conversions to SI that are provided for informational purposes only and are not considered standard.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.