Hello. Sign In
Standards Store

ASTM G76

2013 Edition, July 1, 2013

Complete Document

Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Format
Details
Price (USD)
PDF
Single User
$46.00
Print
In Stock
$46.00
PDF + Print
In Stock
$78.20 You save 15%
Add to Cart

People Also Bought These:

ASTM E18
ASTM E313
ISA RP60.11
AWS D1.2/D1.2M

Product Details:

  • Revision: 2013 Edition, July 1, 2013
  • Published Date: July 1, 2013
  • Status: Active, Most Current
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 6
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method covers the determination of material loss by gas-entrained solid particle impingement erosion with jetnozzle type erosion equipment. This test method may be used in the laboratory to measure the solid particle erosion of different materials and has been used as a screening test for ranking solid particle erosion rates of materials in simulated service environments (1, 2).2 Actual erosion service involves particle sizes, velocities, attack angles, environments, and so forth, that will vary over a wide range (3-5). Hence, any single laboratory test may not be sufficient to evaluate expected service performance. This test method describes one well characterized procedure for solid particle impingement erosion measurement for which interlaboratory test results are available.

Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard (exceptions below).

Exceptions: Table 1 uses HRB hardness. Footnote 7 and 11.2 use abrasive grit designations.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2 The boldface numbers in parentheses refer to a list of references at the end of this standard.