Hello. Sign In
Standards Store
Look Inside

BS 2000-455

2011 Edition, June 30, 2011

Complete Document

Methods of test for petroleum and its products Part 455: Determination of the manganese content of gasoline — Atomic absorption spectrometry (AAS) method

Includes all amendments and changes through Reaffirmation Notice , June 1, 2016


View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
SAME AS IP 455 * INCLUDES CORRIGENDUM
Format
Details
Price (USD)
Print
Backordered
$137.00
Add to Cart

Product Details:

  • Revision: 2011 Edition, June 30, 2011
  • Published Date: June 1, 2016
  • Status: Active, Most Current
  • Document Language: English
  • Published By: British Standards Institution (BSI)
  • Page Count: 14
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

The British Standard1) specifies a method for the determination of the manganese content of automotive gasoline, when the manganese is present as methlcyclopentadienyl manganese tricabonyl (MMT ®)2). The precision of this test method only applies to the determination of manganese in the range of 10 mg/L to 40mg/L, but higher concentrations can be measured by prior dilution of the gasoline sample with the specified solvent to bring the test portion within the specified range of the method. The test method may not be applicable to gasoline containing highly cracked components (less than 18% (viv) olefins as determined by ASTM D1319 non depentanized). Solutions of MMT ® in gasoline are chemically unstable when exposed to light, and low and erratic results are expected if the gasoline is exposed to light prior to stabilization during analysis.

NOTE 1 For the purposes of this standard, the terms "% (m/m)" and %( v/v)" are used to represent the mass fraction and the volume fraction respectively.

1) This standard is based on meterial published in the Annual Book of ASTM Standards, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959. Adaapted with permission of ASTM.

2) MMT(R) is a trade mark owned by Ethyl Corporation and is the trade name of a product supplied by (supplier). This inforamtion is given for the convenience of users of this standard and does not constiture and endorsement by BSI of the product named. Equivalent products may be used if they can be shown to lead to the same results.