Hello. Sign In
Standards Store




Look Inside

CSA ISO/IEC 7811-1

2015 Edition, January 1, 2015

Complete Document

Identification cards - Recording technique - Part 1: Embossing



Detail Summary

Active, Most Current

EN
Additional Comments:
SAME AS ISO/IEC 7811-1
Format
Details
Price (USD)
Secure PDF
Single User
$118.00
Print
In Stock
$138.00
Add to Cart

People Also Bought These:

ISO/IEC 7811-2
IPC-6012
CSA ISO/IEC 7811-7
IPC-A-600

Product Details:

  • Revision: 2015 Edition, January 1, 2015
  • Published Date: January 2015
  • Status: Active, Most Current
  • Document Language: English
  • Published By: CSA Group (CSA)
  • Page Count: 38
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This part of ISO/IEC 7811 is one of a series of standards describing the parameters for identification cards as defined in the definitions clause and the use of such cards for international interchange.

This part of ISO/IEC 7811 specifies requirements for embossed characters on identification cards. The embossed characters are intended for transfer of data either by use of imprinters or by visual or machine reading. It takes into consideration both human and machine aspects and states minimum requirements.

It is the purpose of this series of standards to provide criteria to which cards shall perform. No consideration is given within these standards to the amount of use, if any, experienced by the card prior to test. Failure to conform to specified criteria should be negotiated between the involved parties.

ISO/IEC 10373-1 specifies the test procedures used to check cards against the parameters specified in this part of ISO/IEC 7811.

NOTE Numeric values in the SI and/or Imperial measurement system in this part of ISO/IEC 7811 may have been rounded off and therefore are consistent with, but not exactly equal to, each other. Either system may be used, but the two should not be intermixed or reconverted. The original design was made using the Imperial measurement system.

NOTE 2 TIM (Tactile Identifier Mark) defined by ISO/IEC 7811-9 can be located in the name and address area of this part of ISO/IEC 7811. The layout of embossed characters in this area is not intended to interfere with TIM.

CSA B51