Hello. Sign In
Standards Store

DEF STAN 61-12: PART 26

Revision I3, January 27, 2001

Complete Document

Wires, Cords and Cables, Electrical Part 26: Wires, and Cables Electrical, Dual Extruded Insulation Type Olefin/vinylidene-Fluoride and Screened and Jacketed - Sectional Specification

Includes all amendments and changes through Amendment 2, May 20, 2011

Detail Summary

Active, Most Current

Additional Comments:
Price (USD)
Single User
In Stock
Add to Cart

People Also Bought These:

CSA C108.3.1
DEF STAN 61-12 PART 25
DEF STAN 61-12: PART 0

Product Details:

  • Revision: Revision I3, January 27, 2001
  • Published Date: May 20, 2011
  • Status: Active, Most Current
  • Document Language: English
  • Published By: MODUK - British Defense Standards (MODUK)
  • Page Count: 32
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This standard specifies requirements for airframe wires and cables in temperature category 135°C, with medium and thin wall insulation. This insulation system has been tested for use in aerospace applications using 115 volts (phase to neutral), 400 hertz ac and 28 volts dc. Verification of the suitability of this product for use in other electrical system configuration levels is the responsibility of the user.

These wires and cables are suitable for fixed wiring at temperatures from 135°C maximum down to minus 75°C but are not suitable for severe flexing at temperatures below minus 40°C.

These wires and cables do not support combustion and will withstand contamination by ester based lubricants and by ester based hydraulic fluids.

The thick wall insulated wires and cables, types 2 and 3, are normally available where dimensional replacements for those wires and cables listed in BS 2G 221 are required for wiring without further protection.

The thin wall insulated wires and cables, types 8 and 9, are intended for internal wiring of equipment.